VERTIGO | Polystyrene Panel – Waves

↕️ Panel dimensions : 60 x 60 x 3 cm

Reference : 5001
Composition : Expanded polystyrene
Set of 3

Area calculator

You have 6 m2 to cover, you need 2 boxes. ( m²)

Wide range of more than 100 references

Committed and compliant products

Easy installation thanks to pre-assembly

Products subject to a sorting rule

A simple solution to effortlessly transform your walls

This lightweight and easy-to-install wall covering is perfect for adding depth and structure to any space. Made from expanded polystyrene, the panels feature a 3D wave pattern that creates a fluid and calming atmosphere, ideal for relaxation areas. The relief highlights the natural variations of shadow and light. Suitable for all environments, including humid ones, they can be easily cut, painted, and shaped, offering great freedom for customization. A practical decorative solution to transform a wall and bring character to any interior.

Reference 5001

Data sheet

Composition: Polyester
Use: Inside
Length (cm): 60
Height (cm): 60
Width (cm): 3
Weight (box): 0,75
Compatible near a heat source: No
Number of pieces per box: 3
Number of M2 per box: 1,08
Quantity / Pallet: 36
m2 / pallet: 38,88
Use of seals: No
FSC Certificate: Without Wood
Indoor air quality: A+

Download

DoP VERTIGO - ref. 5001

Download (148.1KB)

Required Tools
• Pencil
• Measuring tape
• Spirit level
• Utility knife
• Spatula
• Fine-grit sandpaper
• Polystyrene-compatible polymer adhesive
• Glue gun

STEP 1: Check the product before installation
• Inspect the general condition of the panels before any cutting or mounting.

STEP 2: Prepare the installation surface
• The wall must be dry, clean, sound, and perfectly flat.
• If the wall is painted or coated, sand or strip the surface to ensure proper adhesion.
• Not suitable for areas exposed to heat (near fireplaces, stoves, etc.).

STEP 3: Dry fitting
• Lay out the panels to anticipate cuts and check the visual arrangement.
• A straight-line layout is recommended for a uniform result.

STEP 4: Cutting and adjusting the panels
• Cut the panels with a clean, sharp utility knife.
• In case of irregularities, lightly sand the edges with fine-grit sandpaper.

STEP 5: Gluing the panels
• Apply adhesive to the back of the panel using a spatula, forming a wave-like pattern and emphasizing the edges.
• Start installation from the bottom of the wall.
• Gently press the panel against the surface to avoid deformation.
• Use a spirit level to check alignment starting from the first row.

STEP 6: Finishing
• Wait 48 hours before painting the panels (only use water-based paints).
• Do not cover the panels during the drying process.

Recommendations
• For indoor use only
• Seamless installation
• Do not expose to direct heat sources

ADIB declines all responsibility in case of non-compliance with the instructions. Installing the product implies acceptance of these conditions; once installed, no claims will be accepted except in the case of hidden defects.